Skip to main content

Strike for surface-mounted electric bolt locks, for frameless glass doors 10–15 mm, SecureEntry-SC20

GTIN: 5907614669058 · SKU: SecureEntry-SC20

The SecureEntry-SC20 is a stainless steel strike (lock catch) for surface-mounted electric locks. It is mounted on the surface of a frameless glass door 10–15 mm thick and receives the bolt of the lock. It works with surface-mounted electric and electromagnetic locks with an extending bolt, and has a position detector that helps lock the door at the right moment. The compact strike takes up little space on the door, and the door can open both ways, by 90° or 180°.

SecureEntry-SC20 stainless steel strike with the rubber and metal pad

Table of contents​

Specifications​

  • Device type: strike for electric surface-mounted locks
  • Material: pure stainless steel
  • Application: electronic surface-mounted locks
  • Suitable door type: frameless glass door
  • Suitable door thickness: 10–15 mm
  • Opening mode: two-way door, 90° or 180°
  • Product dimensions: 96 × 38 × 48 mm
  • Package dimensions: 10 × 5.5 × 5 cm
  • Product weight: 100 g
  • Weight with packaging: 300 g

Kit contents​

  • Electric lock strike
  • Metal and rubber pad
SecureEntry-SC20 kit: the strike and the metal and rubber pad

Dimensions​

SecureEntry-SC20 dimensions in mm: 96, 48, 38, 26 and 17

General safety rules​

  1. Before installation, make sure that the door on which the strike is to be mounted is of the right type (glass, frameless) and 10–15 mm thick.
  2. Install only on a clean and stable surface.
  3. Be careful not to damage the glass or the steel components during installation.
  4. Use the product only with electronic surface-mounted locks.
  5. Check the fastening of the strike regularly — loose components can cause the lock to malfunction.

Installation​

SecureEntry-SC20 seen from the mounting side, with the screws
  1. Place the strike against the door surface and mark the mounting points.
  2. Secure the strike using the appropriate mounting hardware, avoiding excessive pressure on the glass.
  3. Position the strike so that the door can open in 90° or 180° mode.
  4. Check the fit with the electronic lock and perform a test opening and closing.

Operation​

  1. Once installed, the strike works directly with the electronic surface-mounted lock.
  2. The door can be opened freely in both directions, depending on the setting (90° or 180°).
  3. Avoid strong jerks and impacts — they may damage the strike or the lock.

Maintenance​

  1. Clean the strike regularly with a soft, damp cloth.
  2. Do not use harsh chemicals or abrasives.
  3. Once every few months, check the fastening and tighten the screws if they have become loose.
  4. In case of visible mechanical damage, replace the component to keep the product safe to use.
SecureEntry-SC20 strike seen from the side

Frequently asked questions​

Which locks is the SecureEntry-SC20 compatible with?
Surface-mounted electric and electromagnetic locks with an extending bolt, that is locks mounted on the surface of the door.
Which doors is the strike suitable for?
Frameless glass doors 10–15 mm thick.
What door opening angles does the SecureEntry-SC20 support?
The strike supports two-way doors opening by 90° or 180°.
What is the position detector for?
The strike has a position detector that helps lock the door at the right moment.
What is in the kit?
The electric lock strike and a metal and rubber pad.

Downloads​

The manuals and datasheets as PDF, in case an offline copy is needed. Everything in them is also on this page.